FAQ

Which scale should I use?

As you may know, there are different types of Borg Scales. Firstly, the original perceived exertion scale (the Borg RPE Scale®) from 6 – 20 and then the Borg CR10 Scale®, a general intensity scale for scaling most kinds of perceptions and symptoms. There is also a more finely graded CR scale, the Borg centiMax Scale® (also called CR100). All scales are easy to use and to understand and give reliable and valid data, but usually for somewhat different purposes.

The advantage with the Borg RPE scale is that it because of its construction gives data that grow approximately linearly with HR (and oxygen consumption) during steady state work on a bicycle ergometer.

The Borg CR scales® (CR10 and centiMax) are general intensity scales that can be used for many kinds of symptoms. A great advantage with the Category-Ratio (CR) scales is that they are Level-Anchored Ratio Scales that combine the value of verbal anchors for level determinations (How strong?), with ratio data (How much stronger?) giving results similar to what is obtained with magnitude estimation (S.S. Stevens). With ratio data, of course, it is possible to also answer more interesting research questions and apply more advanced statistical analysis. When the correct instruction is used with the scales, Gunnar Borg’s “Range-Model” for intra- and interindividual comparisons applies to the ratings by calibrating subjects with a maximal perceived exertion (of lifting something close to maximally heavy) as a “fixed star”. In this way, direct comparisons between individuals and among different symptoms are possible.

Of the two CR scales, the Borg CR10 scale is the older and most widely used. It has been used clinically, in ergonomy, and in sports and training for assessing perceived exertion, leg fatigue, breathlessness, dyspnea, and aches and pain in muscles and joints. The Borg CR10 scale is the scale recommended by the ATS (2002) for the 6-minute walk test, and by ACSM (2010).

The Borg centiMax scale® (CR100) is a CR scale from 0 to 100, and is thus more finely graded than the CR10 scale. It can be used in any situation where the CR10 scale is used and would be the choice if it, for example, is important for the patient or athlete to be able to give more detailed, finely tuned answers. The centiMax scale has also been used for example for estimating putting force in golf, performance evaluation in diving, in voice perception of hypernasality, in aircraft noise perception and in assessment of depressive symptoms.

For reference, see for example: Borg, G, 1970; Borg, G, 1982, 1998; Borg, G & Borg, E., 1994, 2001; Borg, E., & Borg, G., 2002, 2013; Borg, E., 2007, Borg, E. & Kaijser, 2006; Borg, E., Borg, G., Larson, Letzteer, Sundblad, 2010; Borg, E. & Love, 2017; Borg, E., Magalhaes, Costa, Mörtberg, 2018; Dickson, C., 2009; Molander, Olsson, Stenling, Borg, E., 2013; Yamashita, Borg, E., Granqvist, Lohmander, 2018.

Can’t I just copy a scale from the internet?

BorgPerception AB has copyright and trademark for the different authorized Borg Scales and the instructions that go with them.

Can I use colors on the scales, add pictures, use other verbal anchors or make other modifications?

There are many so called “modified Borg scales” that are forgeries and we cannot give permission or encourage the usage of them. On some there are words that have been exchanged and on others there have been things added, for example colors or pictures, and all this threatens to distort the responses from the scale. The verbal anchors on the Borg Scales have been carefully chosen and placed at their numerical position so that the scale is constructed to give ratio data that corresponds to what is obtained with a psychophysical scaling method called magnitude estimation (that on group level has been shown to give ratio data). See, for example Borg, G., 1998, Borg, G., and Lindblad, 1976.

Another problem with some modified scales is that the dot (•) above 10 at “absolute maximum” has been removed. This may also distort data and induce a so called “ceiling effect”.

On some scales (often called “Borg dyspnea scale”) the word “strong” has been replaced with the word “severe”. This is not good, because the word “severe” does not have a neutral – but instead negative – connotation. If I, for example, have a severe pain, it is likely to be regarded as a serious problem. However, a pain can be “strong” without being at all severe… (for example a strong muscle pain from hard exercise).

Sometimes one can find that horizontal lines have been drawn to introduce categories on the scale (for example for each scale value.) This will likely prevent participants from using decimal points, and may risk reducing the data quality.

Even introducing only a few (for example 2-3) categories, might cause a problem in that it creates “jumps” in the data where data clusters just below each limit. (Similar to a ceiling effect, but for sub-maximal levels.)

The Borg CR10 scale is also a general intensity scale. This means that there is no need to modify the scale in order to adapt it for specific symptoms (with one scale for exertion, another for pain, one for breathlessness, dyspnea, etc.), but the same scale can be used for any symptom that has an intensity variation. So, with a correct administration and instruction, the Borg CR10 scale, can be used for perceived exertion, pain and dyspnea, and also for motivation, depression, anxiety, or loudness, taste, smell, etc. And the values can be compared intra-individually and even inter-individually (so that if I rate my perceived exertion as 8, and my pain as 4 and my dyspnea as 2 and depression as 1, this means that I am twice as exerted as I have pain, and my pain is 4 times as strong as my feelings of depression (etc.). So, actually, you only need the correct Borg CR10 scale. (The same reasoning is true for the Borg centiMax scale.)

Which scale administration do you recommend?

Probably the most common usage of the Borg scales are either in a clinical setting with patients or healthy participants, in rehabilitation, or in sports, exercise and physical training, and with work on a bicycle ergometer or treadmill (or similar). It is then important that the patient or participant (P) is familiarized with the scale. The test administrator (TA) shall read the whole instruction and P shall be given a chance to ask questions if anything is not clear. It is especially important that P understands the reference level “Maximal” and how it is anchored in a previously experienced maximal exertion. It is also important for P to understand the importance of always starting with looking at the verbal anchors, but then to report a numeric response (see Scale instruction). It is an advantage if the instruction is at hand for P to be able to look at during any stage of the test.

Is it possible to use the scales on electronic devices?

Yes. The scale can be used on any electronics device as long as it is displayed in its native format e.g. viewed by a PDF viewer on a tablet.
In addition to PDF it is also be possible to view the scale as a picture. However, BorgPerception only provides the PDF file i.e. the customer would need to create the picture e.g. from a screen dump.

Is it possible to use the scales in IT systems?

Yes. The easiest way is to view the scale as a PDF or as a picture as described above. This secures that the scale is viewed in its native format.

If the scale needs to be implemented in any other way (e.g. in a web format) BorgPerception needs to review and approve the implementation (e.g. via screen dumps).